Page 1 of 1

a bit of busted bolt repair info

PostPosted: March 31st, 2015, 8:55 am
by grumpyvette
obst67 wrote:Hey guys. I'm in a bit of a pickle. I am rebuilding my 350 out of the vette and one bolt hole from the oil pan is pretty mangled. I have no idea what happened because I never did this (previous owner). The hole was originally filled with puddly and a stud was stuck in it. It must have worked because it never leaked oil from that area.

Now my question is what is the best solution to fix this problem. It looks like the person who did it was trying to drill a hole and was no even close to being straight. If I took it to a machine shop could the drill a bigger hole and put a custom threaded sleeve in? Or are there better options. See my picture I attached.
Thank you

the previous owner rather obviously tried to use a hand held drill and failed MISERABLY in the attempt to maintain the drill on the broken bolts center axis, but any decent machine shop
will have little problem removing the remaining threaded section of that bolts and repairing the threads with a helicoil kit.

its one of the reasons I purchased a milling machine, a repair like that generally requires a trip to a local machine shop where they throw the engine block up on the mill, secure it, level it, index the offending busted stud or bolt and center drill it then back the now hollow threaded remainder out with the correct tooling then use a helicoil kit to repair the threads, a job like that is not all that expensive, most machine shops will charge under $40 but its a P.I.T.A. to transport the block, and go back the next day to pick it up or wait while its being done, and after running into several dozen little jobs that required a MILL, and having the skills and experience already personally to run a mill I got rather pissed off at myself for paying $40 here and $60 there on a regular basis for work that basically cost the machine shop pennies to do and said screw this, and bought a mill! now I don,t expect most guys to go out and buy a mill, but having one is very helpful, so thats why a machine shop will generally have the mill and use it!but at the same time I can,t see how any serious hobbyist won,t have a decent drill press in a home shop, and a few left hand twist drill bits and helicoil and easy out screw extractors







Заработок заключается в том что нужно выполнять 7 простых н

PostPosted: February 26th, 2016, 6:25 pm
by Thomasot

модная одежда и обувь

PostPosted: February 28th, 2016, 4:42 am
by Thomasot