Runner removal



Runner removal

Postby snowmanmdp » July 25th, 2009, 8:20 pm

OK....I'm going to try this again, ordered the tpis gaskets to try this again....last time I could not get the back bolts :x Any suggestions are welcome.
snowmanmdp

 
Posts: 11
Joined: April 19th, 2009, 2:52 pm
Location: Michigan

Re: Runner removal

Postby grumpyvette » July 25th, 2009, 10:08 pm

the harder to reach torx bolts youll want to access from the opposite side of the intake, those bolts require a long torx bit and swivel tool for reasonable access
Image

http://www.harborfreight.com/cpi/ctaf/d ... mber=98484
Image

http://www.harborfreight.com/cpi/ctaf/d ... mber=31203
Image

Image

Image

Image


be aware that the lower runner gasket is not interchangeable between the drivers and pass sides of the engine on a tpi and if installed incorrectly that results in hard starts a big vacuum leak and an engine that won,t idle
IF YOU CAN,T SMOKE THE TIRES AT WILL,FROM A 60 MPH ROLLING START YOUR ENGINE NEEDS MORE WORK!!"!
IF YOU CAN , YOU NEED BETTER TIRES AND YOUR SUSPENSION NEEDS MORE WORK!!
grumpyvette

User avatar
Site Admin
Site Admin
 
Posts: 14105
Joined: September 14th, 2008, 1:40 pm
Location: florida


Return to Engine: Repairs and Modifications & generally corvette related

Who is online

Users browsing this forum: No registered users and 2 guests

cron