Removing Dulso from dash parts



Removing Dulso from dash parts

Postby DC-GReaper » October 6th, 2010, 1:20 pm

It's time to redo the interior of my '95. I've already gone the route of replacing all of the dash and console panels that have the dull, rubbery finish (Dulso) that was applied by GM with new pieces. In a little more that a years time in South Florida sun and heat, the new pieces have started peeling while the center console panel finish has actually softened and has become sticky.

I'm tired of it and like I said, it's time to redo the interior. This time around, I want to go with custom painted dash and panel pieces. I've started to remove the Dulso form my old panels. It comes off easily where it began to peel, but is VERY stuborn to remove from other areas.

I was wondering if anyone had any experience in the removal of Dulso or if they have any ideas on what I might try, to make this job easier.

Joe
DC-GReaper

 
Posts: 1
Joined: May 10th, 2009, 11:47 am

Re: Removing Dulso from dash parts

Postby Indycars » October 6th, 2010, 2:34 pm

I had never heard of Dulso before now, but I did find this article about refinishing this type of interior.

http://www.corvette-restoration.com/res ... _Resto.pdf
Rick
Too much is just enough!!!

- Check Out My Dart SHP Engine Project: viewtopic.php?f=69&t=3814
- Need a Dynamic Compression Ratio Calculator: viewtopic.php?f=99&t=4458
Indycars

User avatar
Forum Admin
Forum Admin
 
Posts: 4424
Joined: May 25th, 2010, 8:58 am
Location: Yukon, OK


Return to Interiors/trim/dashes etc.

Who is online

Users browsing this forum: No registered users and 1 guest

cron